Finished the installation today of the Flukso V2.
Water sensor : installed without problems on a Elster V100
Gas sensor : installed with some 'problems' on a Elster BK-G6, had to file off the reedsensor housing top (by hand - don't use powertools) before there was a reliable magnetic contact between the internal magnet and the reedsensor.
Electric (3x220V) : first on the wrong foot by a early picture in the forum of a version 1 installation :-( but after some RTFM .... got it working.
Some things I'm not sure of :
- the calibration of the sensors
- in the syslog there is only one electric sensor reporting, could be normal if I read the manual wright, but to be sure is this correct ? (3 sensor - 3 phase setup)
Luc
Manual section 2.2.3 - if you want to see all phases combined, choose 3-Phase; separated choose 1-Phase...
Thanks for the fast reply Gebhardm ! Seems I was reading the manual good.
Website :
- with the 3 phases graph is there a option to have a combined graph with all the 3 phases without changing the Fluksometer ?
- after a lot of experimenting (in a few days) can I reset the web statistics ?
Q1: No - it's an either or.
Q2: Only if the master of ceremony (icarus75) resets it for you...