Note that the impedance of the clamps attachable to the FLM is fixed by the built-in voltage divider, so not any clamp may be used...
khan123 |
I think this one is pretty close. Product range has the same spec as the one you posted link to couple of year ago :)
gebhardm |
...and you have to get the correct factor set in the configuration for the clamp...
khan123 |
I figure I could choose 50a probe setting and input half the voltage. I calculated the error using 25a probe will be 6W but frankly, perhaps it is better to stick with 50a probe -after all we are talking about 3-6W of better accuracy.
VK6EH Perth |
I would like to order another 50 Amp Clamp to monitor the load taken by a reticulation bore pump which is shared with my neighbour.
I assume connect to the next available port a configure as normal.
Any problems?
Regards
Wayne
Note that the impedance of the clamps attachable to the FLM is fixed by the built-in voltage divider, so not any clamp may be used...
I think this one is pretty close. Product range has the same spec as the one you posted link to couple of year ago :)
...and you have to get the correct factor set in the configuration for the clamp...
I figure I could choose 50a probe setting and input half the voltage. I calculated the error using 25a probe will be 6W but frankly, perhaps it is better to stick with 50a probe -after all we are talking about 3-6W of better accuracy.
I would like to order another 50 Amp Clamp to monitor the load taken by a reticulation bore pump which is shared with my neighbour.
I assume connect to the next available port a configure as normal.
Any problems?
Regards
Wayne