Because i made the step to put solar panels i missing now 1 puls sensor intry on the FLM.
That's why i choose to delete temporary the temperature monitoring and connect to this sensor input the solar generation.
My question is: Once I re-enable the sensor, but now for a other purpose, shall the old sensor data on the Flukso website be deleted ?
edit:
I see now that's not the case !
I have to ask Bart to delete the whole data in the dash ?
@ICARUS75, will you delete all the data that i can start fresh please ?
Do you only want to have the Elec-PV readings flushed? Or the readings of all sensors?
Bart, the Elec-PV readings only will do, thank you :-)
Elec-PV readings should now be flushed.
Thanks.
When i see with mosquito in the terminal this:
/sensor/SENSOR Elec-PV/counter [1403429106,3938493,"Wh"]
/sensor/SENSOR Elec-PV/gauge [1403429106,2,"W"]
a high number on the "Wh"counter, can i also delete this without doing a factory reset ?
Note: the PV is not generating yet..that's why gauge is only 2 watt.
You can by ssh'ing into the FLM and running these commands:
@ICARUS75
Bart,
I've had to make some changes in my fusebox (couldn't split up consumption/generation, so the readings were not correct).
Is it now possible to flush the historical data for "Main" so I can start over again with correct data? (No need to flush data for "Solar" and "Gas" for these data are correct).
Thanks!
Looks like we need flush data button :)
@Lusili done.
Thanks, Bart!