For some reason dash is not showing graphs

For some reason dash is not showing graphs anymore in my account.
Is there some problem with the flukso site?

Greetz,

Steven

AttachmentSize
Screen Shot 2014-01-03 at 21.36.59.png58.68 KB
Fluc's picture

Hi Steven,
Al the leds are light up on the FLM ?
You can always connect your pc directly to the FLM and look on the config pages?
Have you tried to run Mosquito yet ?
https://www.flukso.net/content/live-output-app

bazzle's picture

Did you remember to log in again?
I forget sometimes :(

unixsol's picture

Hi Fluc,

I have 2 flukso's and all leds are up.
When I hoover over the dash page, I see some values, as you can see in the screenshot in my first post,
but graphs are not build.
I think my flukso's are pushing data to the website, when I visit their config page, they tell me everything is 'ok'.

@Bazzle, yes i'm logged in :)

unixsol's picture

I just tried with Mosquito and this is showing me data, so this looks good:

Flukso 1:
/sensor/feabb3000db979a0d2791f4fd4bd3f67/counter [1388911930,117433871,"Wh"]
/sensor/feabb3000db979a0d2791f4fd4bd3f67/gauge [1388911930,72820,"W"]

Flukso 2:
/sensor/ec3c89abfd620c3e27cc2401eed32930/counter [1388911965,65696,"Wh"]
/sensor/ec3c89abfd620c3e27cc2401eed32930/gauge [1388911965,1662,"W"]
/sensor/ec3c89abfd620c3e27cc2401eed32930/gauge [1388911966,1647,"W"]
/sensor/ec3c89abfd620c3e27cc2401eed32930/counter [1388911967,65697,"Wh"]
/sensor/ec3c89abfd620c3e27cc2401eed32930/gauge [1388911967,1647,"W"]
/sensor/ec3c89abfd620c3e27cc2401eed32930/gauge [1388911968,1648,"W"]

Still no graphs at the flukso site

Fluc's picture

And on the site, both Flukso's and sensors are enabled ?

unixsol's picture

Of course, till some time ago, there was no issue.
Then my flukso rebooted due to a breaker cut and since then the site is giving a lot of problems.

icarus75's picture

Root cause was a line voltage set to 400V iso 230V. This, combined with a 250A clamp, resulted in readings being rejected by the input validation of the rrd. If you want I can flush your readings so that the month and year charts will start showing data again as well. The downside is that you will lose your historical measurements.

unixsol's picture

Thanks for investigating, please don't flush our measurements.