My new Flukso arrived a few days ago, I managed to connect to the unit and setup my Wi-Fi but it did take some time to get a connection. Now when I try to connect to add the sensors the unit either hangs or is very slow to connect then hangs when I try to save it.
I have tried it with several computers and different browsers.
What do you guys think that I am doing wrong?
How did you proceed? Did the first install with direct connection of FLM to computer on http://192.168.255.1, that is, follow the installation instructions on https://www.flukso.net/installation ?
Do you try to connect via WiFi (then you need to open the firewall for any further configuration - https://www.flukso.net/content/access-flm-wireless-interface ) or wired (toggled the reporting mode, then you should look up what IP address your router gave the FLM)?
See https://www.flukso.net/files/flm02/manual.pdf page 5 and following.
I did the setup using an Ethernet cable direct from my laptop it took a long time to log in but I finally managed to save the WiFi settings.
From there I tried to save my sensor settings but have not been able to. Most of what I have tried has been with the Ethernet cable.
I find that I can access the internet on my laptop when the WiFi is turned off and the Flukso is connected by cable.
When you say it 'hangs' when trying to save the sensor settings, do you see a pop-up appearing with a progress bar? Does the progress bar turn green in the end? If not, could you post the contents of the log appearing in the pop-up window?
Some times it gets that far but the green bar has never gone past 30% thats all I get.
With not a single line of text appearing in the pop-up window?
If I make it that far I do get a line of text and sometimes the green bar.
I left it running on my laptop last night and this morning it was stuck on Saving Sensor Parameters with no green bar.
I spend a lot of time looking at this.
http://imgur.com/g4XsXQl
I'll do some remote investigation of your FLM today. I'll keep you posted.
@crankcasy Could you bring your FLM back online?
Sorry last two days I have been back at work and I work long shifts 13hrs so not much time after work to try to put it back online.
I had tried doing a full reset using the button the other day and have not been able to log back in at all but I am time limited when working.
I work 4 days on 4 off so I will try again in two days.
Thanks for the help
Cant log into the unit at all now, I have tried for a whole day with no luck.