Version V232 web interface: how to put only ethernet NO wifi
by vandeputtemichel on
Where my Gas probe is, i have NO WIFI ,
so with one of my flusko FLM02 A i need ONLY ethernet
How to configure it with fix IPv4 , fix Gateway,
With the old but better interface it work!
Thanks
De eindjes vertinnen met soldeer doet het ook prima ;-)
pascal_deschepper |
Oeps, sorry, verkeerde post ...
vandeputtemichel |
error message with NOWIFI possible in this aera:
Jan 1 20:55:37 flukso-05edd0 user.err heartbeat[25782]: No route to host
bazzle |
To see old interface add/ at end of xxx.255.1/luci
You can then see old interface with addresses.
Also press recessed button for 4 seconds on side of FLM IF you only want Eth.
Wireless light will go out.
icarus75 |
You can indeed toggle between wifi and ethernet mode by pushing the recessed 'toggle' button between 2 and 5 secs, see the Fluksometer Manual par 1.2. Make sure the FLM has fully booted (pulsing heartbeat LED) before toggling. The wifi LED will go out and the ethernet itf will be put into DHCP client mode.
The old Luci-based interface has been deprecated and is not part of r232 anymore.
vandeputtemichel |
Thank's it work after:
*the recessed 'toggle' button between 2 and 5 secs*
FLM02A Hostname flukso-05edd0 Firmware version232
Time 27/11/2013 12:55:40 Uptime 0days 0h 4min 33s OK
Network Reporting mode ethernet Gateway IP address 123.123.123.254
Flukso.net ping test successful
flukso-05edd0 user.info sysinit: 'radio0' is disabled
De eindjes vertinnen met soldeer doet het ook prima ;-)
Oeps, sorry, verkeerde post ...
error message with NOWIFI possible in this aera:
Jan 1 20:55:37 flukso-05edd0 user.err heartbeat[25782]: No route to host
To see old interface add/ at end of xxx.255.1/luci
You can then see old interface with addresses.
Also press recessed button for 4 seconds on side of FLM IF you only want Eth.
Wireless light will go out.
You can indeed toggle between wifi and ethernet mode by pushing the recessed 'toggle' button between 2 and 5 secs, see the Fluksometer Manual par 1.2. Make sure the FLM has fully booted (pulsing heartbeat LED) before toggling. The wifi LED will go out and the ethernet itf will be put into DHCP client mode.
The old Luci-based interface has been deprecated and is not part of r232 anymore.
Thank's it work after:
*the recessed 'toggle' button between 2 and 5 secs*
FLM02A Hostname flukso-05edd0 Firmware version232
Time 27/11/2013 12:55:40 Uptime 0days 0h 4min 33s OK
Network Reporting mode ethernet Gateway IP address 123.123.123.254
Flukso.net ping test successful
flukso-05edd0 user.info sysinit: 'radio0' is disabled