Looking to buy CT's 50AMPS/100/250 for Flukso v2b

I am located in USA, Texas

Hello,
today I switch my energy measure to pulse meter to Sensor4. Pulses are processed - "Oct 26 16:15:57 flukso-7fb30d daemon.info fluksod[1253]: processed pulse 763ffda3137305a8d04f5f73e90154a3:1666800957:1386.771" but i cant see any graph on my dasboard + no API data values ( sending to Pvoutput ).

How should I proceed? Thank you.

Jakub

27.10.
Update: graph shown only for 2 hour - morning 3:00-6:00, :(

update 2
if I set "constant" in sensor setting to 1 --> graph is ok, if i set this to 1.25 --> no graph data or line graph

update 3
all is ok now :)

Team, I am trying to connect my 100A CT to my PV System to record solar production as well as solar being sent to the grid.

Is there anything special I need to do to my Flukso?
I have V2B

Hi,

i have a Flukso v2 with three 50A Clamps for Sale.

Shipping via DHL worldwide.
You can Contact me via the forum.

Best regards

Johannes

Hello,

I have a problem similar to what's described in https://www.flukso.net/content/no-ip-connect (boots fine until all leds are on, responds to ping, but no heartbeat, no ssh or http access, and reset button not responding).

However the flashing procedure with ap51-flash does not work. I've tried the proposed executable on ubuntu (with some twists to get it to run on 64bit arch) and on windows, and at best I get a stream of these messages in the console :

Any clue on what may be happening? Or another way to flash the firmware ?
I'd hate to have to give up on this flukso device that's been serving me well for the past 10y.

Thx