I have my flukso now for more than 2 weeks and these are my suggestions.
I will post one suggestion per topic so people can react
I have a 3-phase 220V-system.
The minute tab did not work because I had to configure sensor 2 and 3 as "disabled" when using a 3 phase-system. This is counter-intuïtive to say the least.
My flukso has current clamp1 on input 1, current clamp 2 on input 2, current clamp 3 on input 3.
Apparently such a configuration, which is quite common, requires you to mark sensor 2 and 3 as "disabled".
It would be better if the setting of sensor 2 and 3 is grayed out in case of a 3-phase system.
In that case there would be no confusion