Hi,

It would be nice to have if one can combine 2 clamps (2-phase system) leaving the 3rd clamp free to measure other thing. Here in Brazil it is very common to small/medium residences to receive 2-phase (out of three available) plus one Neutral.

Today, I have two choices, set FLM2 to 1-Phase system then, by hand, sum Phase 1 and Phase 2 clamps. Or, the better way, set FLM2 to 3-Phase system and then have Phase 1 and 2 reported as one (sum already computed). The downside of this is that Clamp 3 will not never be used for nothing (my system has 2 phases only).

If FLM2 could be set to 2-Phase system combining only Clamp 1 and 2 but leaving the Clamp 3 out of the math, one could use the Clamp 3 for general purpose measuring (i.e. electrical oven, heaters, etc). This way Clamp 3 would be useful even in a 2-Phase system.

Regards,

From time to time I experience some problems with my flukso box.
It works just fine but sometimes my chart on the dash just stops and
I have to unplug my box and plug it in again.
After 5 minuts every thing works as expected, except I get a straight
line on the chart for the time it was out.

What could be the problem here?

Currently the meter constant for gas is expressed in L/pulse. Wouldn't it make more sense to express it in kWh?

If I just change the meter constant value to the correct factor for kWh (ie. ~litres*0.001*1.02264*40.0/3.6, or in other words a factor of ~0.011362) would it make a difference other than the dashboard chart legend being wrong?

Currently there is minute, hour, day, month and year and night graphs -- however I find myself wanting compare week-by-week measurements (to notice weekend affects). Thus a 'week' graphs would be useful. Any chance this could happen?

Thanks in advance,
Simon

Is there a possibility to have a search function for this forum?