While going through the different forum topics I see a lot of people having issues with 3phase networks without N.

Using the clamps works fine as long as 1 wire is consistently used as N, but most people have some device (cooker) connected as 3 phases or the load is balanced over the 3 phases rather than 2+N

While googling I found these ABB meters ODIN OD4165 and OD4110 that seem to measure the consumption of 3 phases correctly and seem to have pulse output. Would it be possible for me to install one of these and connect it to the Flukso.
Here is a link to the ABB devices http://www05.abb.com/global/scot/scot349.nsf/veritydisplay/0a4b318e8e4b1be8c1257567004961e3/$file/2cmc480022c0002_b_en_electricity_meters__din-rail_mounted.pdf

Are there any alternatives/similar devices to these ABB meters that would do the trick. I do like the idea of the device being a DIN rail device, keeps it very organised and clean.

Thanks

Hi,
I'm trying to install sensor on gas meter BK-G4M but can't figure out what is the right position. Meter looks exactly like the one mentioned in the shop (BK-G4) but with letter M on it too.
Sensor is working , I can simulate pulses with magnet . But I can't install the sensor on the meter to get any readings. Any suggestions ?
thanks a lot

I need to compare kumulative data for a 12 month Periode. Unfortunately i am not able to select a specific time periode in dash year view (e.g. November 2011 to November 2012.) If i move the time selector tab (with my mouse), the selector moves allways arround and cannot be stopped anymore. Any idea?
Thanks Obi

I am unable to access the server - using MAC OS 10.7.5
I receive an error message that the server is not responding
have tried the Flukso toggle button (reset)
any further advice appreciated
thanks

Hi

I've just received and "installed" the Fluksometer. Really, I'm trying to test it first meassuring the EE consumption of one individual appliance.

I'm using a 50A clamp and 230V in my sensor nº1...

The problem is that, you can see in the file attached, Fluksometer indication is 11 W ... but the real data (Current Cost's EnviR meassure) is really about 145 W .

The Fluksometer read ... it live... and the voltage output from the clamp is 8.3 mV.

Any idea to explain this strange behaviour?

Best regards and thank you in advance

Pedro