Hello,

Today i received my flukso.
Installed and configured like the website said.
Device is working, wifi led is blinking slow. So the wifi connection is ok.

But i do not get to see any data of my flukso.
When i connect it again it says that the connection is ok.
Transfer and receive data of the wifi connection changes when i refresh.
I also can visit the flukso.net site.

When i look at de device tab in "my account" i see that the "last heartbeat" is from 2 hours ago and it stays that way. This is the time and date when i put it on power after connecting the wires.

is it possible to add more inputs ( digital or analogue )on a Flukso.
I'd like to messure and power consumption and water consumption.
But with an extra counter I can also messure the level of the water in my reservoir.

Hi all,

I recently found out I have some kind of a strange fuse box wiring. Not a problem ... until ... you actually want to start measuring consumed and generated power (solar PV). I have seen several posts on this topic (for instance http://www.rowetel.com/blog/?p=135 and http://www.flukso.net/content/seperating-household-consumption-and-gener...), but I just wanted to share what about 20-25% people here in Belgium are experiencing.

Guys,

Unfortunately, I'm not able to install current clamps on both the "produced" power and the "consumed" power. The only option I have is to install a current clamp on the total power. I do have an in circuit meter ("GSC" counter) available, so I wonder if it would be possible to properly seperate both powers by taking into account these 2 measurements.
So to resume:
clamp 1=power as close as possible to my energy supplier
GSC output=generated output of the PV installation (type EM10din)

Is the device capable of graphing (clamp1-GSC power)? Are they measured synchronously?

Hi Bart

Is there any way to enable the ethernet port to send the measurements instead of the wireless network.

Regards