I have an FLM v2 broken, so I changed it by a new FLM v3. Water probe is working well. However nothing from the electricity on port 1. The configuration is 1 phase connected to the clamp I used with the old FLM. nothing is connected to ports 2 and 3.

So I have 3 Phase setup , three clamps, when I select Math option to group readings should I see only one sensor in the flukso portal? as I still see six sensors (+ & -). I am trying to hook up to PVoutput for consumption but unsure what sensor I should use

also I dont seem to be getting a wattage reading - its very low on the gauge, am I doing something wrong?

I used to have a flukso v02 which worked perfectly but it died so now have the v03e

regards

BW

Hi,
My old watermeter is gone (died) after years of service.
Where can I buy a decent FLS07A opto-reflective probe which has been explained in flukso's documentation.
You know: a two sided 3M tape on a half moon mirror meter turning arround per liter water consumption + FLS07a probe above it.
Thanks.

Ik probeerde het voorbije weekend even de site energieID.be uit.
Maar zo op het eerste zicht, worden de gegevens niet geimporteerd uit flukso?

Zijn er nog mensen die hier problemen met hebben?

My unit is the FLM02A. I use 3 sensors configured for separate readings. Can I have a fourth curve on the dash page with the total reading of the 3 sensors?