Hi all,

I have just set up my FLM03E and I'm not seeing the correct Vrms value. I'm in Australia and my trusty multimeter tells me I have 240v on the dot at the outlet. I am not using the supplied power pack since it's Euro plug *however* I am using a 1000ma 240VAC in 9VAC out transformer-style Australian plug pack. Would this be affecting the reading? Is there truly something special about the provided plug pack?

Cheers

A couple of years ago I started using a Flukso instalation to monitor my power generation and consumption.
At first I installed 4 sensors but have since reduced this to just 2 (grid and solar) and removed the ones not used.
My question is, how do I remove the sensor information of the two not used from my profile ? The unused ones confuse the situation when I am doing any re-configuring e.g for export of data to pvoutput.

It appears that flukso still remembers the sensor tokens and doesn't drop it off even though they have been long disconnected.
I tried creating another account on flukso but the information was somehow carried over to the new account.

Any help will be greatly appreciated

Cheers
Dennis

Hi,

I get the following error when updating my Flukso.

Saving sensor parameters: ......
Committing changes: true
Syncing configuration: gh 255 2 .. ok
Hardware check (major: 255, minor: 2) .. nok
Error. Major version does not match.
Use -f to override this check at your own peril.
Restarting the Flukso daemon: ok

Any idea?
Thanks.

Paul

FLM02B
Any one retired one they want to move on?

Cheers

Hi Guys

I am having problems trying to get electricity readings with a Fluksometer v3 on a single phase system with 1 clamp (100a). I am in the UK.

I have the clamp attached to one of the 2 x live feed cables to my electricity meter (I have tried both live cables which are clearly marked as such) with the clamp sensor connected to port 2 (I originally connected to port 1 but this didn't work so am trying to rule out possible causes).

I can see some values on the gauges page under port 2 but no watts figure and the 5 amp reading is too low for the whole house.

I am not seeing any readings on the Flukso Electricity dashboard but have confirmed that the electricity sensor is registered.

There are no issues with WiFi access (I Ssh'd in to open the wireless firewall on port 80 so that I dont have to keep unplugging the device from my garage to change the config).

This should be so simple, I almost feel embarrassed that it has beaten me ;-)

The odd thing is that I setup a 2nd Fluksometer v3 in the kitchen to monitor pulses from my water meter and this is working great.