Hi,

I noticed the other day that my PVOutput data had stopped. PVOutput support checked, and said the Flukso API has stopped returning data - 'nan' for both my sensors:

1529322480,"nan"
1529322540,"nan"
1529322600,"nan"
1529322660,"nan"
1529322720,"nan"
1529322780,"nan"
1529322840,"nan"
1529322900,"nan"
1529322960,"nan"
1529323020,"nan"

Yet I'm still seeing data on my Flukso dash. Could someone investigate?

Thanks,
James

I have a 3 phase power net at home. Between phases there is 220V. As far as I know all loads are connected between phases.
On my dashboard I see 3 lines with different power indication.
How should I combine them to calculate my consumed power?

Sometimes when my power goes out, the fluxo boots faster than my dhcp server (which is on a virtual linux machine). If my understanding is correct, the meter will go into dhcp server mode itself, handing out 192.168.255.0/24 to everything else in competition with the real dhcpd.

The results aren't pretty.
Is there a way to turn of this functionality or better deal with this situation? Other than throwing the meter in a separate vlan I'm out of ideas.

Thanks in advance!

12 hours today.Daytime in Oz :(

Hi all,

I suddenly ran into issues with my Flukso (FLM02B, firmware version 250).

As written in another post (https://www.flukso.net/content/flm02b-version-250-inconsistent-number-se...) the dash only shows 2 active sensors.

In the flukso.net -> settings page, there are 12 (!). Now I noticed the following error on my flukso device:

sensor board hardware compatibility check failed Internal error.
Please report this error message to Flukso.

Any pointers how to fix this issue?

Eric