I don't want to be negative and I hope this project runs for a very long time, but as is the reality with many IoT projects that they will eventually finish up.

If this happens, will things still work as they have been (uploading to PVOutput, being an MQTT broker/publisher) and the only thing we miss is the dash on this site? Will the initial setup still be possible?

My flukso is working properly. It runs in wifi mode, I have heart beats and sensor readings are published.

However, I'm trying to make my flukso accessible over Wifi.
Should be easy by following the instrunctions on : https://github.com/flukso/flm02/wiki#configurationlocal-flm-access-via-wifi

However, reloading / restarting the firewall gives me following error:

root@flukso-819523:~# /etc/init.d/firewall reload
Warning: Unable to locate ipset utility, disabling ipset support
Warning: Section @zone[1] (wan) cannot resolve device of network 'wan6'
* Clearing IPv4 filter table
* Clearing IPv4 nat table
* Clearing IPv4 mangle table
* Clearing IPv4 raw table
* Populating IPv4 filter table
* Zone 'lan'
* Zone 'wan'
* Rule 'Allow-DHCP-Renew'
* Rule 'Allow-Ping'
* Rule #5
* Rule #6
* Rule #7
* Rule #8
* Rule #9
* Forward 'lan' -> 'wan'
* Populating IPv4 nat table
* Zone 'lan'
* Zone 'wan'
* Populating IPv4 mangle table
* Zone 'lan'
* Zone 'wan'
* Populating IPv4 raw table
* Zone 'lan'
* Zone 'wan'
* Set tcp_ecn to off
* Set tcp_syncookies to on
* Set tcp_window_scaling to on
root@flukso-819523:~#

Any hints to solve this?

Thanks !

When I connect a dongle with a SIM card to the USB port of my flukso, and I configure it in the 'network' tab, I don't get internet acces. How can I slove this?

When I connect a dongle with a SIM card to the USB port of my flukso, and I configure it in the 'network' tab, I don't get internet acces. How can I slove this?

My electricity year chart has disappeared how do I get it back.

Has this to do with installing of a 2nd flukso