After a defect i got from Telenet their latest white model modem. no problems with any devices except Flukso.
On the web interface I can choose my wifi and fill in the correct key. After saving the wifi led does not light up at all and after some time the globe goes dark.
I put up a personal hotspot on my iPhone and connect to that => the Flukso works fine.
I did an upgrade from 247 to 250 trough my phone, but still no connection possible with Telenet.
Included are the wifi settings from the Telenet modem

Thanks in advance,

Martin

I just got a v3 flukso to replace a v2A as i needed extra S0 ports
i presumed that the analog ports 1-3 could be set as S0 ports?

i cant find out the settings in de webui nor in the manual

any help appreciated

I have installed a Flukso and the electricity and water readings work fine, but my gasmeter is in another room. Is there a way to install a wireless link to transmit the pulses from the gas meter sensor to the Flukso port ? Thanks

Is it still possible to buy / find V2 compatible power clamps?
I have a new setup where I would love to measure additional imput on my flukso FLM02A.
The ones listed in the shop are incompatible with the V3 so if someone can help me out would be greatly appreciated.

KR

Dieter

Hi,

A long time user here and have a V2 and V3 fluksometer now.
The V2 had 1 LAN port which gets an IP address and is available through my home network. Happy days there.
The V2 has 2 LAN ports (WAN and LAN). If I read the manual correct the WAN is uplink and the LAN is downlink.

So just to be sure. This is the behaviour I have at this point:
If I connect the internet to WAN the heartbeat is ok and data is uploaded to the Flukso service. However I'm not able to open the GUI as I only receive a ping on the IP address given by my router.
If I connect my laptop directly to the LAN port I can connect to the device on 192.168.255.1 and configure everything.
If I connect both the WAN and LAN to my switch (and the internet) the internet is working but the device GUI can not be reached.

Is it somehow possible to change the management IP for LAN to the range of my network (192.168.0.X) and be able to both connect the WAN port which is getting an IP from my router and the LAN port with fixed IP in the same range so I can connect to the GUI without needing to physically connect my laptop to the LAN port.

All suggestions / feedback whether I'm missing something here are highly appreciated.

KR

Dieter