Here the situation:

- FLM02B running and operative (installed yesterday)
- Connection to web site good
- Power monitoring with 1 50A clamp good and stable. I can see on internet my data as expected
- Mosquitto running. I can get data coming from analog meter

Now the problem part

- Port 4 and port 5 configured for pulse input
- Hardware and sensor connection seems good.
- No signal detected. No graph on internet. No data from mosqitto.
- I tried to shorting also port 4 and port 5 to simulate a pulse, nothing. No pulse reported
- Many reboot and different test: no solution found

It seems for me an hardware failure. Do you have some extra suggestion to solve it ?

Hi all

I noticed that the firewall block access from wifi to port 80. Good for security, but what about MQTT 1883 ? Is it blocked on wifi ? If yes, how can I change this setting ?

Regards

Giacomo

My Flukso FLM02A is dropping its wireless link after a few days and refusing to re-establish the link without a power cycle. As it's currently in the meter box, WiFi signals are listed as between 15/70 and 19/70 (i.e. quite low).

Is the dropout a known issue? Am I going to have to connect up to the ethernet port and scrape some logs, and if so what commands should I run or what log entries should I be looking for?

FYI my WiFi AP is a Fritz!Box 7390. I have no wireless connectivity issues on the other devices in the house, and there are no other networks on the same Radio Channel as me (at least there aren't when I check the Access Point to see if somebody is stomping on my channel).

Hello guys. A simple question, is there any way / method to test if my daughterboard (metering board inside Dragino daughterboard) is running properly. I put logread | grep pulse in command prompt but I have no data. My clamp is connected OK, all the connections are ok, etc and the fluksometer is doing heartbeat properly. Thanks in advance for your help.

Antonio.

Hello,

i have a big problem with a flukso electrical sensor. In the minute display i get every time the error: "Error - The call for sensor L3 experienced a timeout. You are probably not in the same local network as the FLM.‏"

Is the sensor L3 broken?

mfg