Hi,

Is it normal to FLM to display serial number as unknown in the first page of WebGUI? I noticed this today but I received the latest upgrade while ago.

Since it is working very well I don't know if it is problem or not.

Thanks

I bought a flukso a couple of weeks ago second hand. I cannot get it to operate properly at all. In the flukso dash when I click on the minute tab it tells me "Error - The call for sensor Consumption experienced a timeout. You are probably not in the same local network as the FLM. "

Also it shows under the year tab info from way back in March 2012,which is way before I even had the flukso. I have included a link to a screen shot of the graph.

https://www.dropbox.com/s/kno5s5a0a0s89j6/strange%20flukso%20info.png

If any body has any advice it would be much appreciated . I have just about given up on it. Thank you..

On the 9/10 between 12.00 and 12:45 I got the perfekt test on my Fluksos, A poweroutage.
Sadly all of them showed some watts even though there should be none.
the highest recording was 9028 watts.
All 10 clamps where steady in their readings troughout the poweroutage.

Is there som calibration to do or is there another explanation?

/Peter

Hallo All,

Is there a way to change the colors of the graphic line. In my case the line of gas consumption are in red, before I installed my PV readings the line of power consumption red, after the installation of the PV reading they switched around consumption blue production of the PV red.

Is it possible to use the gas (and water) probe with a raspberry pi ? Can you connect this directly to the GPIO of a pi ?

Thanks !