After selecting upgrade, the FLM has several errors that have me concerned.

On the FLM's status page it now correctly reports firmware version 232 however there is an error message.
{"message":"Method not found.","code":-32601}
The message is displayed at the top of the status page in red.
In the status field is says.
Status synchronisation with sensor board failed Internal error. Please report this error message to Flukso.

On the syslog page i see correct pulse processed messages and POST messages but i also have the following message.

Nov 6 10:25:04 flukso-569bd8 user.err fsync[1049]: fsync exit status: 3, synchronisation with sensor board failed

I thought this might be the same issue reported on https://www.flukso.net/content/no-heartbeat-or-data-after-upgrade but i checked the two files and there were no extra lines in the files. I did add my FLM's serial number to the /etc/config/system file to see if that was causing the problem. It was listed as Unknown before i added the correct serial number (FL02001982). Although the status page now reports the correct serial number it has not fixed any of the other issues.

I read an old forum post https://www.flukso.net/content/flukso-heart-beat-and-synchronisation-sen... with similar symptoms where icarus75 went in remotely and fixed the failed sensor board flash.

Might this be the same issue and require the same fix?

All Data Prior July 2013 missing.
Went to year graph and its incomplete.
Can it be retrieved?

Baz

After upgrading to the new 232, I get this error message. The globe Led is switched off.

Thank you for your help

Michael

Oct 29 08:32:23 flukso user.err heartbeat[1032]: POST https://api.flukso.net/device/0123456789abcdef0123456789abcdef: 401
Oct 29 08:32:23 flukso user.err heartbeat[1032]: WWW-Authenticate: No proper provisioning for this device

Hi,

I've set up my flukso to measure my main circuit, then 8 of my sub-circuits. I have 3 more lighting circuits which I would like to show on my flukso dashboard, in addition or (preferably) instead of, by calculating the difference between the main and sub-circuits.

Can I do this through the /etc/config/flukso file?

Thanks,

Alex.

Hi there,

I scheduled upgrade to my Flukso and it happened. WebUI show version 232.

But now I keep receving message like:

{"message":"Method not found.","code":-32601}

And "Sensor config synchronization" shows:

"synchronisation with Flukso server failed"

every time I load the page. However Fluskso seems to be working very well besides this strange UI messages.

Any clue?

Thanks