Hello
Tonight I turned off my netgear router and then back on again and the flukso has not made a conection back to the wifi network (globe led not on) Will it connect automatically after a certin time?

It will connect again if I go out to the power meter and turn fluksos power off then back on. Should I have to do this??

Cheers Brad.

2 flukso's on the same wifi network ..... would this be any problem .... should it work OK?

THANKS

Hello
I have just set up my Flukso and it seem to be working fine on small loads but when I turn on my A/C (big 3 phase unit) the power measurment seem way to high.
Will I have to set the line voltage to a lower value?

I live in Australia and we have 240 volts and our 3 phase is 415 volts. Has the fact when my A/C is on it is using all phases at 415 volt divided by 3. Will that cause it to show a high reading?

Thanks Brad.

I cant believe this unit can give so much hearthache..
It stopped responding this morning.
I reset power.
I tried to see thru wireless then lan cable.. nothing, cant display web page (for Flukso box, was 192.168.0.11)
Tried to reset Flukso??

Instruction in latest manual timing seems to be different?
Mine resets at 10 sconds to defaults (need SSID reentered etc etc)
Did that a few times. :( (finally got back to 192.168.255.1)
Tried to cycle wireless function, same with timing.and diff led sequence.
Mine has solid glow, 2 flashes per sec and no glow (couldnt find that in manual?)

Added Internet conn manually to match assigned in cable router.(192.168.0.11)
Can see web page for local Flukso again.
Flufso server ping test failed on sensor page too..
Do I need a new unit?

I copied latest syslog below.
Absolutely stuck and bewildered that something can torture me like this unit does. Been at it now off and on since 7:am this morning, 10pm now..nite :)

Edit: Irrelevant sys.log data removed

Unit now functioning 3 days later..............see later post, Baz

This might be a stupid question but how do I find out how many phases I have in my house?

I live in Belgium and I suppose it's the same for all residential houses here but the question can be more generic: how does one find out how many phases are used?

Thanks!