Installation

Questions about installing and configuring a Fluksometer.

The network setup...

I have been able to setup the WAN side of the flukso (WIFI) - and I have been able to add the device to my account on the flukso.net site.
The WAN IP I assiginged using the manual settings was 192.168.1.20.

So its talking to the world.. However I cannot get to the web interface via this IP.

If I plug the flukso directly into my pc I can get to it on 192.168.255.1 - but thats no good to me once its in my meter box, I need to be able to get to it wirelessly.

Any idea why it is able to talk to the flukso site but I cant get to it in a browser?

Is there a way to stop FLM taking over as DNS provider for my wired network?

I have reset the FLM's wired and wifi network addresses to 10.10.0.4 (wifi) and 10.10.0.5 (wired) so it I can access it from my 10.10.0.*/24 home network.

BUT my wifes PC started using the FLM as it DNS provider. After I turned my PC on this morning it also grabbed the FLM as it's DNS provider. I have noe hardcoded my PC and wifey's PC to use my router as the DNS provider, but was wondering if there is a way to get around this?

My have adjusted the network settings to (bold are the new settings):
Local Network
IPv4-Address: 10.10.0.5
IPv4-Netmask: 255.255.255.0
IPv4-Gateway (optional): 10.10.0.1
DNS-Server (optional): 10.10.0.1

Internet Connection
Protocol: manual
IPv4-Address: 10.10.0.5
IPv4-Netmask: 255.255.255.0
IPv4-Gateway (optional): 10.10.0.1
DNS-Server (optional): 10.10.0.1

Clamp Segment Size: unchecked.

I have the FLM operating in wifi mode.

Should I be expecting any more dramas or is there something else I can do to ensure that the FLM is not acting as a DNS provider? Does it need to be a DNS provider now that it is on my network.

Thanks all. Apologies for being a pain :-(

re-install firmware

Can you give details instructions to re-install the firmware of my flukso v2 ?

thanks ...........

Silly question: How search the forum posts

How do I search the forums?

I just got my FLM2 today and I am having some issues getting it up and running. Before I break out all the noob questions I thought I would search the forums as I can't believe I would be the first person to have dramas setting these up.
- - - - -
Problems I am having:
1) My wifi LED is blinking sporadically (about once every 1 or 2 seconds). Definitely blinking faster than once every three seconds [good wifi], and slower than twice per second [no wifi connection]
2) How do I tell what reporting mode the FLM is in?
3) On my Flukso devices page I can see that my FLM has previously registered a heartbeat (half an hour ago), but the uptime is listed as "0d 0h".