Installation

Questions about installing and configuring a Fluksometer.

Wrong time hour change

Spent a along time trying to find out why my BST hour change did not happen on my flukso ,I got it to work eventually, connect via ethernet cable, log in , and save your sensor page for it to upload, worked for me.

edit... hmmmm worked ok on the log in page of the flukso but checked pvoutput.org and it was still wrong ...ahhhhhhg
For UK now need to change in settings to GMT+1 on pvoutpt site , now all working !. I hope this helps someone.

Solar panel measuring not accurate...

Hello!

Same problem that quite some people have here with measuring solar panels with a clamp.

An overview... maybe someone sees the logic:
- at night, there is a constant measuring of 50 Watt on the Solar circuit.
- if I switch off the fuse of the solar installation this drops to 25 Watt?
- during day, the reading is 50-100 Watt higher than the numbers shown on the inverter.

So I'm thinking to buy a phototransistor to stick to the red LED on my DIN kWh meter installed. Any pointers to a model that should work are welcome...

Lua error when selecting system on the webinterface

I get following error when clicking on the system link in the web interface and it seems that the heartbeat isn't working any longer either.

I noticed there is an update for the firmware is it possible to upgrade the device manually?

below the error

  1. /usr/lib/lua/luci/cbi.lua:338: Unable to read UCI data: system
  2. stack traceback:
  3.         [C]: in function 'error'
  4.         /usr/lib/lua/luci/cbi.lua:338: in function '__init__'
  5.         /usr/lib/lua/luci/util.lua:70: in function 'Map'
  6.         /usr/lib/lua/luci/model/cbi/mini/system.lua:21: in function 'func'

Flukso v1 (rev 1.2) for Sale

Hi,

i want to buy a new Flukso v2, so i don't need my old Flukso V1.2 any longer ;-)

I would offer it for 35€ including shipping cost for Europe.
The power clamps are not included!

If someone is interested drop me a message.

Greetings

Johannes

Can no longer SSH into my Flukso

Must have done something really STUPID...

Followed a post to only use LAN-settings for communication to/from my flukso-device.
I have some aberrant network settings, so i had to do some adjusting...

Now ---> i no longer have WLAN, which is OK (that's what i wanted).

Which is not so OK i can no longer access
1) the web-interface via LAN
2) i can no longer ssh to the device by LAN

In my LAN-overview in my router, i can see the flukso with an IP-address 192.168.xxx.20
In the dash on your website i can see the figures it's sending (so that's OK for the moment)