The Flukso device seams to be able to collect any measurable data.
Which sensors for Gaz and Water are compatible ?
What could you propose ( reference , price ..) ?
Thanks

Hi all,

I'm a Canadian user so I have a 3 Wire Edison system - two legs that are each 120V to neutral and 240V leg to leg, I have it set up with two 100A current clamps. Right now I have it set to a single phase install with sensor 1 set to a voltage of 120 and sensor 2 set to a voltage of 120 and I call them L1 and L2, respectively for Line 1 and Line 2. I have a few questions:

1. My actual voltage is around 122/123V per leg, should I change the settings to reflect this? What will give me the most accurate calculation?

Hello,

my Flukso failed suddenly. First, were delivered to two analog channels any more data. After a reset (> 10 sec) I can no longer connect to the IP address 192.168.255.1. If the Flukso V2 is defective or any other default IP address used for? The Heartbeat LED illuminates continuously.

Regards Heinz

hello there

i had to install my flukso outside because my powerpanel is there.
It is protected but very cold....

so my question :
what are working conditions for the device ?
at the moment we have - 15C...

regards
Christoph

Hello there
i've installed the Flukso properly ; i think....
can read the correct Sensor names and device.
Got 3 Phases R, S, T and clamped the sensors
wired +/- corectly
can ping the device via WiFi
but after resets ( counted ) and one hour i've got still do data displayed in the dash ( hour )

what can be wrong ?

thanks a lot ! in advance