Installation

Questions about installing and configuring a Fluksometer.

Simple questions

Hi,
I love your product but it leaves me with a few questions.

A: version2 has 2 pulse ports, which sensors should one use on these ? and where to buy

B: How to decide which powerclamb one needs

C: does the system work on a 3 phases installation (like mine)

D: how is the flukso powered (battery or main power outlet)

E: posibility to measure water/ gass consumption how do I accomplish this ?which sensors do I need ?

F: is it possible to make my own charts by getting the output via network using for example snmp ?

Gaz and Water Sensor

The Flukso device seams to be able to collect any measurable data.
Which sensors for Gaz and Water are compatible ?
What could you propose ( reference , price ..) ?
Thanks

New Canadian Installation / User

Hi all,

I'm a Canadian user so I have a 3 Wire Edison system - two legs that are each 120V to neutral and 240V leg to leg, I have it set up with two 100A current clamps. Right now I have it set to a single phase install with sensor 1 set to a voltage of 120 and sensor 2 set to a voltage of 120 and I call them L1 and L2, respectively for Line 1 and Line 2. I have a few questions:

1. My actual voltage is around 122/123V per leg, should I change the settings to reflect this? What will give me the most accurate calculation?

no IP-connect

Hello,

my Flukso failed suddenly. First, were delivered to two analog channels any more data. After a reset (> 10 sec) I can no longer connect to the IP address 192.168.255.1. If the Flukso V2 is defective or any other default IP address used for? The Heartbeat LED illuminates continuously.

Regards Heinz