Hello there
i've installed the Flukso properly ; i think....
can read the correct Sensor names and device.
Got 3 Phases R, S, T and clamped the sensors
wired +/- corectly
can ping the device via WiFi
but after resets ( counted ) and one hour i've got still do data displayed in the dash ( hour )

what can be wrong ?

thanks a lot ! in advance

Here I go again.

Program shows server ping test failed.

It stopped earlier today and a couple of times yesterday. Hasn't come good yet.
Any ideas where to look or is that the remote server not the white box near my switchboard?

Bazzle

Ive been reading my Flukso thru a lan cable plugged into the side of a notebook to adj sensors, get ip addy etc. outside next to the switchboard.

Can I read the Flukso on my nework thru wireless(1) or run the lan cable to a port on my wireless router that my main pc is plugged into(2)

If so how do I access? Any clues?

Bazzle

Just got my Flukso today in the US. I have two 120V legs. When I initially set it up I configured it as a single phase in the configuration. This showed a value for both legs in the house. So I changed it to a three phase hoping it would total the sensors, but it doesn't seem to be doing that. I am only getting the values for one leg.

What is the proper configuration? Does it need to be set as single and then I manually add them or is there a way to get it to total everything up?

Thanks!!

If I buy a Flukso will it be able to display its outputs to my live solar generation on pvoutput.org.
If yes is it easy to set it up to do this.

Thanks Brad