Hi,

We have 4 Flukso devices running on 4 different locations. (4 shops) We have them added into 1 account. 1 device is showing "NAN", other devices are showing the Watts.
After pulling out the 220Volt plug and putting it back in the wall it works for some days.
What can be done?

Gr.

Kristof

Hello everybody!

I have a (Schlumberger) RF1-G4 at home (Brussels) and I spent most of the week-end to try to get some pulse out of it with a reed sensor without any success at all...

Here is a picture of the meter: http://www.e-bulles.be/images/rf1-g4.jpg
(I used an Arduino board to detect the pulse)

So does anyone know exactly where the magnet is located? (which digit?)
(It says 1 pulse / 0,1m3, so it should be on the 2nd decimal...)

Maybe my reed switch is not sensible enough, I tried with what I had in my stock...

I'm trying to read a pulse from an energy meter, which has an 'extra' module installed which apparently sends out a modulated pulse. Accessing the actual meter is not possible, due to the sealed box its placed in. (The seal is placed by the power company)

When trying to measure the output of this module, my digital multimeter registered 3V per pulse. As it is quite a slow one, and the pulse is pretty short, i'm guessing the actual value would be around 3.3V

Now, my question is; will this pulse signal be useful to wire to port 4 or 5, without breaking the thing?

What's the expected accuracy of (for example) the 50A clamp?

Reason I ask: I finally got my cabinet rewiring done, so I can measure total consumption. I was already monitoring 2 suspect sub-circuits, and now I would assume that sub1+sub2 <= total - however, that's not always the case. currently sub1+sub2 = 406W and total = 391W.

Hi all,

I've one of the first V2 fluksometer. How to keep it up to date ?

Here my /etc/opkg.conf :

src/gz packages http://downloads.openwrt.org/snapshots/backfire/10.03.1-RC5-testing/athe...
dest root /
dest ram /tmp
lists_dir ext /var/opkg-lists
option overlay_root /overlay

Can I use the last stable release of BackFire ?

Ho to upgrade flukso up to date too ?

opkg list-installed|grep flukso :
flukso - 2.0-beta-1

Thanks in advance,

Cyril Feraudet