Hi all,

I would like to know the power consumtion of my heaters. Can I pass all
my heaters phase wire through a single power clamp ?

All my heater are on the same electrical phase, but through different
wire ...

Thanks,

Cyril

Good day.
I have managed to connect the Fluksometer in the the Flukso website. Then I had the sensor installed by an electrician. Do I need to register the sensor as a device on the Flukso website? When I try to enter the Sensor serial number it states that it is not a valid serial number. The sensor does not show on my account at all {and therefore no measurements are pulling through :-( }.
What am I doing wrong?
Many thanks

Hi,

I have 3 phases without N at home. According to another thread it's impossible to correctly measure the current with the clamps. I was wondering if there doesn't exist a sensor that can be attached to the electricity counter. In Belgium there is a wheel whith silver stripes that moves according to the energy consumption. An example can be found at http://www.alsolar.pt/strom.php?spr=uk

Thanks
Stijn

Geachte,

Ik heb onlanks een flukso meter gekocht, en ben zeer tevreden.

Ik kan zowel mijn gas als water inlezen dit via halsensors ( besteld bij farnell) info -> http://lika.be/wp/2010/03/xpl-enabled-utility-meter-monitor/

De voeding (3,3V) heb ik verkregen via de de 'a'-ingang van poort 6 + en de - op de 2 ingangen (4 en 5) de puls op de Vout op de + ingang van 4 en 5.

Alles werkt perfect,

Enkel weet er soms iemand hoeveel 0.01m3 gas in liter is ?

Mss kan flukso de omrekening van gas naar Kwh eenvoudig aanpassen ?

Sven

Hello everybody,

I just installed a new Flukso and it is working like a charm.
But how to get rid of the old device under My account > devices.
I can add a new one but I can't delete the old one

Best regards,

Henk