Installation

Questions about installing and configuring a Fluksometer.

Wifi configuration: SSID not visible

Hey everyone,

I've got a problem with the configuration of the FLM's wifi page:

I initially installed the FLM at my own house, with my own wifi network and SSID, and here it all worked fine.

Now I'm trying to install the same FLM at the house of a client. Their local wifi network, however, does not appear in the drop-down list of SSID's the FLM can connect to... I can only connect to the networks of their neighbours? The list of networks with which my pc can connect on the other hand, does contain the required wifi network, and is much more extended than the one I can see and select on the FLM wifi page?
It also does not seem possible to manually configure the FLM's SSID?

Hopefully someone can help me out...

Best Regards

please specify a valid serial number.

Hi,

When I try to add my Flukso to my account Devices here at flukso.net I receive an error that says 'please specify a valid serial number'. The serial number I'm using is on a sticker on the device itself, and also in the web UI so I know it is the correct number.

I did buy the device as part of a package from the company that did my solar installation so I'm wondering if this has been registered to the account they used to purchase it, so I cannot take ownership of the device?!

Has anyone come across this issue before? Really frustrating :)

Thanks.

Tristan

single or tri-fase Belgium, 2 wires and no neutral

So, I'm in Belgium, and there are 2 wires coming in the main board, both live, no neutral.
115v between Line and ground, 230 between the live wires.

How do I configure? 2 clamps as Tri-fase with 115V or 1 clamp and single fase 230V?

I've connected now 2 clamps and configured single fase 230V, and on the graph I get the right reading, but 2 graphs (almost the same), so the 2 reading combined (total) gives the double of the actual value.

What would be the correct configuration?

best regards

Fonnie

Gas Probe wire lenght

I would like to connect a Gas probe to my FLUKSO. But its distance from the Gas meter is about 10 meters.

Is it ok to extend the Gas probe wire by 8 meters?
Are there special requirements for the extension wire?

Thanks for your help!

Connecting to PV Output

I just got my Flukso working on the dashboard, I am now trying to connect it to PV Output. I can not find the Token anywhere.

Any suggestions?

I have tried the sensor page as others have suggested but it's not there.