I am running wifi at home with hidden SSID but the fluksometer installation GUI doenst let me manually configure the SSID. It requires that I Select it from a list of SSID's that it can see. Is there any way around this ?
Regds Alan

All,
I've setup my fllukso today for solar monitoring via pulse input
I have a 100 pulse/kwh
What factor do I need to setup , is it 10 or 0.1

For water I used the factor 2 as mentioned in the e-shop

Would it not be a good idea the use the pulse count iso the factor

Thans in advance,
Yves

@icarus75
Hello Bart,

I refer to the following thread, where Johan Crols got his minute tab working by deleting the smart main sensors, which are being installed automatically:

https://www.flukso.net/content/minute-tab-flm02b-anyone-got-it-working-y...

Maybe that's the reason my minute tab is not working either. I also have a smart main-electricity and a smart main-gas sensor I didn't install myself. So is it possible to disable them both?

Thanks!
I let you know the result as this can be interesting for more people with this problem......

Accuracy of the Flukso solar measurement.

I start to wonder how accurate is the solar measurement with Flukso.

My setup for measurement and comparison:

A: kWh dinrail meter with S0 output to Flukso
B: kWh dinrail meter with S0 output to Qurrent ( dutch Site )
C: measurement to SolarEdge Portal
D: measurement to Pvoutput.org taken from Flukso
C:Monthly measurements from A and B manualy

When I compare A and B the difference is about 2,45 kWh per month, there fore
a assume that the dinrail meters are within the specs.

When I compare the output of B with the output of SolarEdge portal, B is of
by 350Wh at 12,5Kwh output.

So i can assume that the measurement of the portal is also with in the
limits.

Now for the tricky part

When I compare the Measurments from PVoutput.org ( input by A ----> Flukso
----> pvoutput.org) to the SolarEdge portal, PVoutput is approx 28% to high.
there for the measurement of Flukso is to high.

Not so strange when look at the graph of Flukso it show 3402 W from a 3060Wp
installation

At this moment I'm correcting the output from PVoutput.org so that it comes
more in line with the output of the SolarEdge portal.

My question is there away within Flukso to correct this.

I have 2 Flukso's at different locations , each locally connected to a wifi network.
They where both initially working.
By working I mean when i logged into dash account there was 2 lines on the graph - ie one for the sensor from each flukso's.

(Each has just one port monitoring the electricity consumption for the respective house.)

However one graph stopped at exactly Fri July 25 12:00

However, devices webpage shows last heartbeat received (from the flukso) at 26 Jul 2014 16:01:06 . ie very recently.

Question is, why has the graph (for this flukso) with this sensor stopped?

THANKS