Installation

Questions about installing and configuring a Fluksometer.

Solar panel metering not visible in graph

Let me first explain my setup, which is -I think- a bit different the most others-

Since I want to meter gas + water + electricity + solar and I have a 3 phase without N net, I can't use clamps, since I don't have enough ports for that.

This is what I've done:

port 0: (which is always analog) --> not used
port 1: pulse --> gas: works perfectly
port 2: pulse --> water --> works perfectly
port 3: pulse --> connected to my din rail PV meter (see attachment)

other ports not used yet.
I'm planning to use port 4 as pulse for metering my 3 phase electricity, but didn't find an affordable (second hand?) DIN rail meter yet...

Anyhow, it seems that my PV meterings are not visible on the site..
Is this because I didn't use port 0, or is there another reason?

Thanks

Flukso Water Probe - Delivery Price

I installed my water probe that I made using a small reed in my water meter http://i1289.photobucket.com/albums/b503/Molari1/WaterMeterNew_zpsda3113... but it is working only occasionally. So I looked at the Flukso shop and found a water probe for 9.68 Eur = 8 EUR without GST. When I entered my address in Australia the shipping to zone 5 cost standard 48 EUR !!!

It is slightly high IMO :)

So I am wondering if it will be possible to send it in usual Air Mail for few euros?

Also I am wondering what is the length of the Flukso Water Probe.
Tx

RTFM questions?

Hi,

I have a some short questions I would like to ask to get the full picture.
My IT knowledge is not a problem...I'm affraid of the non-IT tasks/choices.
Hope this forum can help me with it.

My intention is to measure:

o power consumption
o solar production 8500WP (3 phases?)
o water consumption
o gas consumption

1) So If I'm right I need the B model because I want to measure 4 different channels?
2) Where can I find the info on the type and amount of clamps I need to buy for the power measuring?
3) My meters are about 4 meter away from the fuse box. Is this not too long for the water/gas cabling?

BR,
Christian

No power (only water pulses seem to work)

I'm new here, and I have my flukso only a week or so.
The problem is that I don't see an electric chart on the dash. for water I get a chart.
I have a 3 phase installation with 100A clamps and 1 Water sensor.
This is what I see in the sensor table (sensor id and token made shorter) :
Sensor Token Type Function
d7...bf d4...ce electricity p1
ce...c9 ed...37 electricity smart-main
28...c7 bc...f1 gas smart-main
9a...a6 c6...ea water water
I only filled in the funstion P1 and Water into the device, I don't know whre the smart-main came from...

Any Idea?