Krijg bovengemende fout, altijd en iedere keer. Nu al circa een half jaar.

Firefox (F12 dev mode) zegt hierover:

Gebruik van getPreventDefault() wordt niet meer ondersteund. Gebruik in plaats daarvan defaultPrevented.
Laden van gemengde actieve inhoud “http://192.168.1.48:8080/sensor/f498046d7ce1c034f5367bc7f74a5ba1?callback=jQuery17102365083448438181_1402321164010&version=1.0&interval=minute&resolution=second&unit=watt&_=1402321166652” geblokkeerd[Meer info]

Wat nu?

I installed the gas sensor on my new FLM for 4 hours now and still no response.
I noticed that the gas sensor is mentioned 2 times in my account. Two times as "Type=gas" but by "Function" there is once "gas" and once "smart-main". Maybe that is the problem. How can I remove them and install it once again. I already tried to re-configure the ports, but that didn't work...

To be sure: how must the sensor been placed? Letterside towards the digits or otherwise? Not very clear what the "laserside" is....

Thx!

How to connect the clamps properly: what is the correct direction concerning the marks "K" and "L" on the clamp? Or doesn't that matter?

Thanks for the help!

Hi,

I want to use a Fluksometer for my German electricity meter (EMH type ehz-IW8E2A5L0EQ2P, see http://shop.co-met.info/artikeldetails/kategorie/zaehler/artikel/amh-dre...) for saving data automatically to Pvoutput. The data I want to gather is the kWh consumed and the kWh returned by a PV system.

In Germany they use the Smart Message Language protocol and D0 interface on electricity meters which can be read by using an Optical Probe (see several 'Schreib-Lesekopf' on http://wiki.volkszaehler.org/hardware/controllers).

Does anybody know if it is possible using the Fluksometer in combination with an Optical Probe?

Cheers,

Vince

Just installed my FLM yesterday and all seamed to go OK, but no data displays in the dash board yet. It shows message: "Error - The call for sensor Mains experienced a timeout. You are probably not in the same local network as the FLM."

I've already RTFM and tried both, ethernet and wifi server connection modes and wifi and ethernet host pc connections. All LEDs are on, heart is beating at 1s (approx).

Syslog contains entries like this at regular intervals: Jun 3 10:57:06 flukso user.info heartbeat[24886]: POST https://api.flukso.net/device/5eaf3d422c5e9671475b3f3d1e44903f: 200

I've configured only one sensor and the FLM was able to synchronize with the server. Currently I'm using wifi for server connection and ethernet for local network connection. My host is Windows 7 at this moment (started installing a VM with Ubuntu).

Several posts in the forum point to server connection issues and sensor configuration issues, tried their recommendations with no success.

Am I missing something? Is there any test I could do to solve it?