Hello All!

I'd like to place an order for the Flukso device. I'm mighty interested to start running energy consumption stats oproperty ouscompromised not just bapartments,e I'm a stats geek but also to significantly reduce my footprint on our little roquestion: doringly called 'Earth' in this vast galaxy.

Just to precisely clarify for my own purposes AND for the future internet denizens looking to achieve the same:

1) the Flukso V2B unit will be fully functional for the use on the electrical grid of the USA (I'm in Chicago, to be specific), correct?

2) I own one property that has 3 separate circuit breaker boxes with 3 separate electrical meters, each corresponding to it's own breaker box. This property is comprised of 3 rental apartments, hence the 3 circuit breaker panels / electrical meters. My question: can I use 1 Flukso V2B unit for all 3 breaker panels? Possibly by installing the clamps "outside" of the 3 breaker boxes, and clamped at the point where the mains split off to the 3 breaker boxes? I wish to only have stats of electrical usage for the property as a whole, not necessarily per individual apartment unit.

3) all 3 circuit breaker panels are of the 250 Amp or less type, so the 250 Amp clamps would suffice? Would a 250 Amp clamp also work perfectly on a 100 Amp panel?

Any knowledge, suggestions or advice = greatly appreciated. I may pay in the form of 1 case of beer should anyone come up with a most crafty answer ;-)

Thanks!!

Dear Flukso community,

I'm not sure which current clamps I need to order and if I can connect any probe to my Water/Gaz. Could you please check the pictures at this link?

https://www.evernote.com/shard/s275/sh/0d4d8064-729e-48ec-a179-709f50ef7...

Thanks for your support!

Cheers,
Matthieu
@maleroy

Hi
My (Email P1) electricity meter's S0 output is rated at a maximum of 2mA.
Will this be compatible with the Fluksometer's pulse output?
I currently use a clamp but am looking for more accuracy
Cheers

Hi, I recently purchased a Flukso V2b to monitor a S0 DIN-rail meter and a P1 Dutch smart meter (= ISKRA 382).
Yesterday, I installed the FLM just to start with the smart meter, had a little broken lead problem with the RJ11 cable but finally repaired, checked it with a multimeter and connected it.
The FLM works fine, but it gets no readings from the smart meter. To check, I registered a dummy pulse S2 sensor and if I pulse the S2 port, I see the pulses in the log and on the dash of flukso.net. I read the manual, but I cannot find any lead to start with.
On flukso.net the smart-main sensors are there, 1 for electricity and 1 for gas.
All leds on the FLM light up, except when the local laptop is not connected to the Ethernet cable.
Can anybody help?

Hey all,

Just got the three phase din meter wired in by the sparky.

Could anyone shed some light on what the constant value i'd need to put in for the pulse sensor connected to it? The din meter does 400imp/kWh

So far i've got the following settings on the sensor

Type: Electricity
Voltage: 230 <-- I thought power in Australia was 240v ?
Current: 50
Constant: ??

Any help would be appreciated :)

Thanks
Adam