Installation

Questions about installing and configuring a Fluksometer.

Monitor just circuits, not mains

Trying to understand this a little better.

1) Can I use this to clamp only to specific circuits? (not the mains)
For instance the 40A circuit that has my air source heat pumps on it. Or the induction stove circuit. Or the electric water heater...etc

1a) Would I use the 50A clamp in the above cases? Even if the circuit is only a 20A or 15A one?

2) I understand I am I limited to 3 such inputs? is that correct? The other ports are for other sources of data, not the current clamps. Correct?

This would be in a typical US residential application.

Which probe for UGI G4 gas meter [has small mirror on digit 6]?

Hello all,

I scavenged the net but wasn't able to find a more or less ready made optical sensor for getting a pulse from my gas meter. The gas meter has a small mirror on the last digit 6.

Is there someone out there who has connected a similar gas meter to a Flukso?

What I'm after is a sensor which I can build myself as I'm fairly handy with a soldering iron.

An idea I came across: use a CNY70 (but how?) eg. http://www.jojos-homepage.de/ft/cny70/index.html

The jpg of the meter is attached.

Thanks, all ideas are welcome. - Jos

Connect to internet via Ethernet port and GSM router?

Hi, for an industrial application I would like the Fluksometer to connect to the internet via it's Ethernet port and a GSM router. Specifically, I can't connect to the WiFi network at the site, and I wish to avoid creating my own WiFi network such for the Flukso.

Can anyone recommend a low cost GSM router? For example, I found this one, but it has a serial port, not an Ethernet port: http://www.tcam.com.sg/product_tmn51.html

Flukso minute readings + ping work; no output to flukso.net

My Flukso does not have a very strong signal and sometimes loses connectivity to flukso.net it seems. I have pinged the flukso for a few hours and see about 5% packet loss (due to the bad signal), but can use the minute-graph to see the current output. The hour/day graph however does not update for hours and usually needs me to either reset (and lose data) the flukso, or connect my laptop to the ethernet port (save settings at sensor-page).

Could it be possible to change any settings to make the Flukso less sensitive to connection problems (or make the flukso retry to establish a connection more often)?

Gas meter GMT GT4 works with gas probe

This meter works fine with the gas probe.
You have to remove the plastic cap first.

The image upload isn't working so here is the link to the image: foto