how do i get my Hot Water System consumption and water meter readings to the extended tab in pvoutput?

I had written a database on a raspberrry pi to log data from the FLukso's local measurements (using itsIP). this was working fine (using zeroconf to find the Flukso's IP) until i wanted to check the configuration using the local Ethernet port on the flukso. after this it stopped working.
I tried updating the firmware but that failed and i bricked it. I unbricked it using the instructions here:
https://www.flukso.net/content/no-ip-connect
which worked OK. I have tried updating the firmware again which as worked (now at version 247). Sensor values are being logged to the flukso website as normal.
The configuration says the local sensor service is enabled but it is not appearing over bonjour anymore (what is is attached)
What can i do to recusitate it?

Looking through SSH the flukso.service file is missing from /etc/avahi/services

and calling the url http://[local ip]:8080/sensor/[sensorid]?version=1.0&interval=minute&unit=watt&callback=realtime

returns 'no such file or directory'

Hi all

I've been using a watts clever for a little while and just purchased an FLM02B. I hooked up my existing clamps to the Flukso and the readings were present, although ~6 times higher than actual consumption (as compared to the Watts Clever). The current setting just sends the readings higher. The voltage is set to what it should be (Australia, 240) so I'm not sure what to do next. The clamp type I have is same as attached image, 25mm style.

Cheers

Hi all,

I sell 3 x 50 amp clamps because I installed an electrical counter on my installation. I would be happy to sell them for 50€.

If interested, please leave your mail and/or phone: http://goo.gl/forms/hv4eXaOklS

Cheers,
Greg

Hi,

I have a very high powerconsumption I can't explain.
Therefore I want to monitor each seperate group individually to determine where this high powerconsumption is comming from.

I already use a Fluksometer device which monitors my total power consumption throug a P1 connector.

Can I use this device also to measure with clamps without breaking down my existing setup?

Any advice would help.

Thanks.

Paul