Team,

Sense the upgrade to Firmware 250, One of my Electrical Sensors is not reporting data to flukso but I do see it on the logs graving data.

How can I trouble shoot this issue?
Ideas and help welcome!
TIA.
Regards.

Hi I've been looking around the internet for something which can replace using manhours to walk to each electric meter and write the number of kw/h is being used. You see I work at a factory where they pay a different for the electricity used in electric waterheaters from the electricity used for lighting or the machines. So they have this

Electric meter with a pulse output 1000 Imp/kWh MID approved
EAN: 4010312501207

where someone is reading these manually.

Can I set up a FLUKSO to read the pulse output 1000 Imp/kWh from the meter and have it send the data wireless to a computer? And will it work with 15 of these all over the factory?

Hi. I have changed my internet provider and router and now I need to get into my Flukso wifi to set it up again. I cannot remember the password for the flukso. I have connected by Ethernet from Flukso to the laptop, but can't get past the password to log in to set the wifi up.

I changed the password to get into the flukso forum and thought it would be the same, but no go. So, does anybody know what I need to know? Thanks.

Hi,

not sure where to put this.
I've still an old flukso meter.
Recently I'm seeing negative values in the graphs.
For example today at 22:20 I had -41000 ...
At that time it will not be due to the PV installation ... and normally the wiring is so that it doesn't measure the the PV part.

Time to replace the meter/sensor, or some hiccup in the site displaying the info ?

Regards,
Kris

I have a Few issues

I have 1 water meter with a pulse counter connected atm
its a 10L per pulse yet my graph shows it as using 1 or 2 liters etc.
Constant set at 10

how when its a 10L/pulse?

https://www.dropbox.com/s/nzdscd6n8zreg35/10L.p.PNG?dl=0

i can understand it averages it from the last pulse to the current one but its graphing it all wrong, when it varies a few liters here and there up and down but hasnt actually used 10L
unless im getting my constant wrong i dont know whats going on

imo it should average the usage from the pulse before to the pulse after i dont know how it can get readings inbetween the pulses

i have 2 more water meters one a 5l/Pulse that gives random pulse readings
ie. i test with air the meter will read 100L used and the flukso graph shows 36L
i test again and do another 100L and flukso graph shows 56L?

i set the constant to 1 so it would count pulses and i could work out if it was infact a 5L/Pulse unit but the pulses are way out with the same usage.

and the other one is a 0.5L/pulse that wont even get a pulse.

are they not compatible with the flukso or is something else wrong?
or is air (that still spins the meter some how affecting it? i dont want to plumb it all up then it not work and be stuck